Description
- Additional information
This is the Winchester 1200 1300 Extractor, factory part 24102, for 12 and 16 gauge breech bolts.
The circled numeral on the side is a mold cavity identifier from the molding tool. It is not a part number, not a gauge marking, and it varies from piece to piece off the same line — the factory number for this extractor is 24102 regardless of what numeral is molded in.
Condition: Used. Uniform gray, no finish remaining. Fine even surface texture across the flat faces. Claw shows no chipping or deformation. Mold cavity number present on the side.
Included: Extractor only, the exact part pictured. The extractor spring is a separate factory part, 25102, and is not included.
Fits:
- Winchester Model 1300XTR, 12 gauge 3″ Magnum
- Winchester Model 1200, 12 and 16 gauge, both serial ranges (below and above 382,500)
- Winchester Model 1400 and 1400 Mark II, 12 and 16 gauge, right-hand
- Winchester Model 1500XTR, 12 gauge
- Winchester Model 1200 and 1300XTR 3″ Magnum, 12 gauge
Does not fit: 20 gauge guns of any of these models — the 20 gauge extractor is factory part 78102, search that number instead. Does not fit the left-hand Model 1400 Mark II, which uses 16211LH. Not for the Model 12, Model 97, Model 42 or Model 1887. We have not verified interchange with the Turkish-built SXP (Super X Pump), so do not assume it.
Fitting: Extraction part. Seat the extractor fully in the breech bolt and function-check ejection with dummy rounds before live fire. If the bolt will not close fully into battery, the arm is standing proud on the back side and needs relieving. Compare against the part you are removing.
Fitment taken from the Winchester Component Parts catalog dated January 2, 1980, covering the Models 1200, 1300XTR, 1400, 1400 Mark II and 1500XTR.
Please note: Buyer is responsible for verifying correct fit for their specific firearm. Installation should be performed by a qualified gunsmith. Please review all photos, as they are part of the description and show the actual item you will receive.
Condition: Used. Uniform as-sintered gray surface, consistent across all faces including the claw notches and molded radii, with no corrosion or discoloration. Molded cavity number 2 on the side, clearly legible, with ejector-pin witness marks near both arm ends. Hook is intact — leading edge square, no chipping, rounding, or lipping, and the notch interior is clean. Part is straight with symmetrical arms and no visible crack at either arm root. Light burnishing on the arm contact faces from use.
Additional information
| Weight | 0.2 lbs |
|---|---|
| Dimensions | 7 × 5 × 0.5 in |
| Part |
Extractor |
| Brand |
Winchester |
| For Gun Make |
Winchester |
| Model |
1300XTR, 1400, 1500XTR, Winchester Models 1200 |
| Gauge/Caliber |
12 Gauge / 16 Gauge |
| For Gun Type |
Shotgun |
| Country of Origin |
United States |
| Color |
White Steel |
| Material |
Steel |
| MPN |
24102 Extractor |
