Description

Additional information

This is the Hi-Point 995 Gen 1 Rear Sight Frame Assembly, the sight body with its aperture, for the first generation Hi-Point 995 carbine in 9mm. The windage adjustment is functional.

Hi-Point has built the 995 since 1994, and the rear sight changed over that run. The sight Hi-Point sells today is a single design shared across the whole carbine line — the 995, 1095, 3095, 3895, 4095 and 4595 all take the same replacement kit. This is the earlier Gen 1 sight, which predates that consolidation, so compare it against the sight on your own carbine before ordering.

Included: Rear sight frame assembly with aperture, the exact part pictured. Mounting plates, mounting screws and the elevation screw are not included.

Fits:

Hi-Point 995 carbine, 9mm, Gen 1

Fitting: Fit your own plates, screws and elevation screw, then confirm the sight moves through its full range of adjustment without binding. Re-zero at the range before relying on it.

Please note: Buyer is responsible for verifying correct fit for their specific firearm. Installation should be performed by a qualified gunsmith. Please review all photos, as they are part of the description and show the actual item you will receive.

Condition: Used, good. The steel frame retains its full black finish with light scuffing along the outer edges and high points from handling, no rust, no pitting, and no bends or twists — it sits flat and the mounting holes are clean and unelongated. The molded polymer aperture is intact with the Hi-Point logo crisp and unworn, no cracks, no chips, and no stress whitening around the pivot. It hinges freely on a fully seated pin, the ladder serrations are sharp, and the screw is present with an undamaged slot.

Additional information

Weight	0.2 lbs
Dimensions	7 × 5 × 0.5 in
Part	Rear Sight Frame Assembly
Brand	Hi-Point
For Gun Make	Hi-Point
Model	Hi-Point 995 Carbine
Gauge/Caliber	9mm
For Gun Type	Rifle
Country of Origin	United States
Color	Black
Material	Plastic, Steel